When I was getting into the hobby, I did a lot of research on different brands, styles, etc. ![]() These readings were performed on Sportsman incubators at the same time.Īlthough I don't run the sportsman incubators, that is one of the reasons I didn't go with them. Has anyone else check to see if there reading are 1*(one) degree different between the water tray and the 3-egg trays? Using the incubators heat source and the two mercury bulb thermometers. Prior to checking the temperature, I re calibrated the GQF 1502 analog thermometer that was supplied with the GQF 1502 Sportsman incubator. I will assume that by moving the rocker switches to the next levels of, 5,6,and 7 this will increase the incubator temperature by (1) one degree, also showing the higher temperature reading at the water tray and a (1) one degree drop at the 3-egg trays.Īgain, this was tested with the ambient temperature at 66*(degrees) in my incubator house. This was check using (2) two mercury bulb thermometers. The temperature readings on all 3-egg tray levels will be at 100*. Moving the rocker switch settings to position 4 with the ambient temperature of 66*(degrees) the incubator will run a temperature of 101* at the water try on top. The temperature readings on all 3-egg tray levels will be at 99*(degrees). I have found that with the minnie rocker switch settings set at position 3 with the ambient temperature of 66*(degrees) in my incubator house, the incubator will run a temperature of 100* at the water try on top. Inside building temperature: 66* (degrees)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |